filament guiding cone for Ikea Table

I needed a new filamentguide throu my ikea lack table enclosure, because the first one that i made had to sharp edges and the diameter was too small. This causes much stress on the filament that it always ripped off.

This new guide has cones on both sides wich meed at the middle to reduce the stress in the filament.

Hope you enjoy it ;)

Print instructions

Category: 3D Printer Accessories Print Settings

Printer Brand: Anycubic

Printer: All-metal Mega

Supports: No

Resolution: 0,2

Infill: 10%

Filament: Janbex PLA orange