SPD Bicycle Cleat Adjust Tool

Design is intended to allow more repeatable accurate adjustments of SPD (MTB) shoe cleats.
53
267
3
1595
updated October 5, 2024

Description

PDF

Design is intended to allow more repeatable accurate adjustments of SPD (MTB) shoe cleats.

Not necessary but embossed text looks better if you do a colour change at 0.8mm Z height and a change back at about 1.4mm {Note the slicer photo attached is a MMU type colour change - you can do colour change without the MMU) .

Appreciate feedback / suggestions to improve.

Length of the tool was largely determined by my print plate and my size 43 shoe :)

There are plenty of You_tubes on cleat adjustment to give options on best setup.

Need to rotate print 45° for a 200 x 200 print plate. If you do you may wish to change the infill angle as well to 45°.

Print is designed to have the Text side down on the print plate.

I used PLA (eSun ) with 0.2mm layers. No supports or rafts are required

Tags



Model origin

The author marked this model as their own original creation.

License