Universal Joint Necktie

Hello, I posted this model a while ago on Thingiverse but I figured it could go here too.

The inspiration for this model was a design by “sirmakesalot” (https://www.thingiverse.com/thing:26075) but I found theirs kind of sucked so I designed one myself.

I also may remake the top part of the tie to allow for it to be better affixed to the collar of a shirt, so maybe look out for that. 

To print: just use a lot of supports and it should be fine. To assemble: be carful the tabs that connect each piece are easy to break off, also the center hole on the top piece and the middle tab on the bottom triangle piece is to connect a piece of fishing line to support the weight of the tie (the tie wants to pull itself apart). The two holes either side of the top piece are for a piece of twine to go around your neck under the collar. Lastly the slot on the top piece of the tie is to slide over the top button on a shirt (but be careful the tie is more than capable of tearing the button off your shirt!).

Hope y'all like it!