Raspberry Pi Official 7 Inch LCD 30° Mount/Bracket for 2020 Extrusions FLSUN SR

This is a remix from the idea by jterranella (great idea by the way). I needed a bit of an angle (ca. 30°) to make the Pi and monitore case nice and straight (and even!) on my FLSUN SR. I also added some chamfers and rounded corners just to please my OCD ;-) !

I mounted the bracket to the extrusion using M5x12mm screws and t-nuts. The LCD was mounted to the bracket using M3x12mm screws.

In the photos you can see the Pi/LCD mounted permanently ;-) to my FLSUN SR.

Remember to give my thing a"like", its very much appreciated :)

https://www.buymeacoffee.com/murdrrdbypirates

Thank you

Print Settings

Printer:

FLSUN Super Racer

Rafts: 

No

Supports:

Yes

Resolution: 

0.2 mm

Infill:

25%

Filament:

Polymaker PolyTerra PLA

Black

Notes:

Lay the bracket on its back and use supports to the buildplate on the shortest angled piece.

Category: 3D Printer Accessories