I wanted to put all my Dremel accessories in the Dremel box, included in my new set, but the sponge inserts wasted soooo much space. So I decided to make it fit. First I tried to design a 4 piece design, but that would lack modularity, so redesigns would be a nightmare. Than I found the Gridfinity templates.
I made adapter plates fit in the box, and made holders to minimalize wasted space, caused by the grid's step size. Therefore some of the upper level tool holders need to be on the back edge of the grid, because they need the extra space. (And they not fit other gridfinity setups)
I printed all on PLA, no supports. You can save some filament, if you reduce the number of bottom layers, or the infill %.
The Dremel 8260 holder is needs a lot of refinement, it is wobbly it could be much better.
The “Box” is an optional filler, and only one of the two big disk holders needs to be printed.
The author marked this model as their own original creation.