This is a straight driving ETV (Egg Transport Vehicle) for the 2015 division C Science Olympiad, Scrambler. It should be fully rules complaint but check dimensions before using this design.
Note: At time of upload, the design has not been tested in competition and has no guarantee of performance.
Note: The pictures included with this design show a Launcher Backpack installed, but this is not part of the original design and is a separate download.
=====================================================
Printed Parts needed:
1x Block Bar (Final)
2x Speed Bird - Axle
4x or 8x CD/DVD Hubs
1x Egg Block (to make it a Scrambler)
=====================================================
Hardware Needed:
12x M3 6mm Square Head Bolts or M3 6mm Wing Bolts
2x Makerbeam Extruded Aluminum Beams (300mm used in pictured cart)
8x #8-32 Nuts
1x #8-32 Wingnut
1x 1' of #8-32 thread rod
=====================================================
Info on the Design:
(2022 thoughts on a 2015 design) [under construction]
Category: Engineering
The author marked this model as their own original creation. Imported from Thingiverse.