Hand Tazer Prank toy

This is a Hand Tazer I have made for my purposes.

To make it you only need to 3d print 1 file and the listed parts below.

Parts needed:

3D printed case (Amount - 1)

Tp4056 charger with type-c port(Amount - 1)

12mm self-locking Self-Recovery Plastic Push Button Switch momentary 3A (Amount - 1)

18650 cell  (Amount - 1)

wires (Amount - at least 50cm)

M3 bolts, nuts and washers (Amount - 2 of each)

DC 3V-6V bis 400kV 400000V Boost Step up Power Module High Voltage Generator (Amount - 1)

In the picture you can see how it should look assembled, if you have any questions like the wiring diagram, then just send me a message here!