Stewart the Soap Penguin

Here is Stewart. Stewart is a penguin. Stewart collapses to fit your soap bar even after a lot of use. This make Stewart look very funny when he gets small. 

This stylish soap holder is made to look like your soap is the belly of a penguin. This effect is enhanced if you paint around the eyes with white or any other color which you think will look cool. I don't have paints and don't know how to so I used white clay to give you an idea of what it may look like. Since the soap stands upward, it is able to drain completely, unlike flat soap holders which leave water on top of the soap bar. The water flows to an area on the bottom piece but then flows down a “pipe” until it…uhh…takes a leak. There is space to grab the soap from both sides even with a full bar so you don't have to disassemble the penguin unless you want to clean it. It stands on two feet and a little tail so it should be fine for most bathroom sink situations. I think printing in medium blue or light grey will look the best but I only had a black spool on hand so this is what that would look like. This is my first ever model that I am posting and I am relatively new to 3d printing and modeling so sorry for any model imperfections.