Twisted Lamp 2.0 - no base, all lamp

This is a version of the Twisted Lamp that completely removes the base, makes it light up evenly on every side, fixes the split parallelogram and speeds up the print/uses less material.
It is also slightly higher with a size of 242mm.

Materials & Software used:

• D1 mini / ESP8266
• 2m LED strip, WS2812, SK612 and may more supported. Either 30 or 60 LEDs/mm
• 4 M3 bolts
• a bit of wire
• Power supply + cable
• Software used is WLED. It is very easy to install and got many effects, however feel free to use something else https://github.com/Aircoookie/WLED

Print settings:

• no supports needed
• 0.3 mm layer height
• 0.56 mm layer width
• white filament

• removed the base
• fixed the hull
• lowered print time