Yea, your STL file needs re-exporting. In the Bambu studio slicer it gives a no-geometry error. typically because when you export an STL file, with binary settings on the model it can corrupt easily. (I downloaded models 1 by 1)
Sidewinder X1 Waggster Mod BLTouch with improved Fan Duct
I wanted and improved fan duct that does not interfere with the Waggster Mod for BLTouch. Combined the two in Tinkercad.
34
754
1
5171
updated February 9, 2020
Makes
Comments
Could you tell us what the offset is for this please?
Not sure if based on older 33, -33 or newer 28, -33!
File "large_display_sidewinder_x1_waggster_mod_bltouch_.stl" seems to be corrupt and cannot be loaded in slicer. Perhaps consider a reupload. Thanks.
L'impression s'est bien passé.
J'ai pu remplacer le fan et ajouter le BLTouch sur ma Sidewinder X1
Can't load into slicer !
It works fine on my side
Not Bad