Twisty fidget

I realized after I printed this that it was too small for my drill bit that I wanted to use. The file name was 1-5mm, so I thought it would fit. It's supposed to be 1.5mm (I think). So, after breaking one of the gripper arms, I decided it would make a good twisted fidget. Have fun with it.

Print Settings

Printer:

HICTOP 3DP08

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.2mm

Infill:

50

Notes:

You need to sand down the round nub of the top a little for it to fit onto the drill. If you are printing multiple copies at once, you might need a raft or brim to keep the shafts from being knocked down. (This happened to me mid print.)