Small retraction test with marks

I really managed to get it worse and worse with each iteration

how do you set it on prusaslicer?

Very good retraction tower. I have modified the bottom, because of build plate adhishion. (edited)

very useful to quicly test retraction settings

Simple and fast to print. Thanks!

Thanks for this! I used both to tune my retraction settings.

I used the first one to tune for a direct drive setup. I set the retraction changes from 1 through 5. Looked at the best retraction block and then printed the bigger one. For me the best retraction was 1. So with the larger one I set it up to test retraction from 1.1 to 1.9.

1.6 looked the best so then I reprinted the large one again. This time I set it to retract from 1.61 to 1.69.

In the end, 1.64 turned out to be the best. So thanks again. Loving the current print that’s going right now after using your models.