Phanteks Evolv Shift XT AIO Mod

Phanteks Evolv Shift XT case modification to fit AIOs over *60mm tall. Made to fit the Phanteks Glacier One 240 30T AIO. But will work with other AIOs as well. The mod was designed to blend in with case. 

*Will fit up to 70mm tall incurrent state.

• Filament used: PETG (Prusament)
• Standard PETG configuration used in Prusa Slicer. Added support only to middle of Rear Extension part ( Nozzle : 240°C / Bed: 80°C 1st layer - 250°C/90°C After 1st layer)
• Need four #6-32 / 3/8" Pan head, Phillips screws. 
• Top-Front plastic guide rails need to be removed to fit Locking screw pegs extension.
• Do not over tighten any screws. Screw down until secured snug. 

Feel free to remix this to your liking!!