RC brushless motor cable clip / hold down

Here is a simple way of organizing and securing 3-wire brushless motor leads on an RC boat, plane, or car. A small zip tie runs through the bottom to secure the two halves in a tight bundle. I used 2mm wide zip ties, but there's a bit of wiggle room if you have wider ones on hand.

This was designed for 12 gauge wires, but i have included the Fusion 360 file if you want to modify for different gauges.

I recommend printing with a 0.4 mm nozzle and 0.15 mm layer heights. PETG worked well for these prints, but I'm sure PLA or ABS would also be fine. Place the parts on the build plate with the outsides facing down. Don't use any supports. The bridging is pretty minimal and shouldn't pose an issue for most printers if you go slow and use a cooling fan.