Razor Holder

This is a razor holder that I designed for my wife so that her razor would have a home in the shower, and a spot to dry off after its use.

Important: I printed it in the orientation shown in the third picture. No supports were required. You could print it with the big flat side down, but the overhang may be too big for some printers.

I used two 3M poster/hook adhesive strips with the pull tab to attach this to the shower wall, and it has been staying put with no adverse effects from the direct or indirect moisture in the bathroom environment.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 V2

Rafts:

No

Supports: 

No

Infill:

20

Filament:

Matter Hackers: MH | Build PLA

Blue

Category: Bathroom