Iveco Daily Mk IV Cabin Filter Intake Mesh

A mesh to fit the cold air intake that leads to the cabin on an Iveco Daily Mk 4. The wire mesh that sits in the rubberised cover was missing from my van. The rubber surround was still there with 8 stubs of rubber where the mesh had been attached.

This product fits into the rubber cover and slots over the rim to prevent movement.

Although this is in the engine bay, it's also in a constant flow of cold air when moving, so PLA should survive.

To allow air through, your printer settings are VERY important to create the mesh. You can change the infill density for a finer or large mesh but 25% seems a good amount.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Infill:

25

Filament:

Notes:

Wall Thickness: 5mm
Top/Bottom Thickness: 0mm

Infill Density: 25%

Infill Pattern: Grid