A hinged bracket designed to carry an E3D V6 extruder.
This remix adds a hinge system that opens to approx. 90 degrees to allow easier/quicker access for maintenance.
Print it all at 0.2mm with 20 - 25% infill. Support material is advisable when printing the bracket section.
The printed pin works well to fix the hinge - I found it best to keep it pretty rough on the clean-up.
The clamp is locked by an M3 @ 20mm (or slightly longer) bolt and nut. If the bolt is slightly long just heat it and push it into the hole until you have enough clearance.
Category: 3D Printer ExtrudersThe author marked this model as their own original creation. Imported from Thingiverse.