This is my Desktop Induction heater!
This device uses the following components
Induction Heater Module - https://www.amazon.com/gp/product/B01GDVVANA
Small Glass Slide - https://www.amazon.com/gp/product/B0049B3YXQ
400w MOSFET - https://www.amazon.com/gp/product/B07NWD8W26
Momentary Switch - https://www.amazon.com/gp/product/B07WVGTQ1W
Power Switch - https://www.amazon.com/gp/product/B07B2S5QYN
Magnets - https://www.dynavap.com/dynashop/accessories/other/dynamag/
Tall Jar 16 oz wide mouth bell - https://www.amazon.com/Ball-60000-Regular-Mouth-Mason/dp/B001DIZ1NO?th=1
Short Jar half pint wide mouth kerr - https://www.amazon.com/Kerr-Half-Pint-8-Ounces-12-Count-1-Case/dp/B00A0KUGYU
The power supply I had was a 12v 5a. that came with its Female Barrel Jack connections. No link available
Full album with additional information - https://imgur.com/a/SJZkiim
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
10
Filament: Overture PETG Black/Gray
Notes:
Supports only needed on the inside of the electronics compartment. Looking into adding a slope to that to remove the need for supports.
Category: GadgetsThe author marked this model as their own original creation. Imported from Thingiverse.