Flick 'em Up!: Dead of Winter Storage Solution

Summary For those who own the table top game: Flick 'em Up!: Dead of Winter you'll know that storing all the pieces in…
1
32
0
619
updated May 7, 2022

Description

PDF

For those who own the table top game: Flick 'em Up!: Dead of Winter you'll know that storing all the pieces in a neat and tidy way is a lost cause. This box set includes separated areas for each major component to keep the box tidy.

Notes

This is a work in progress - All measurements are done assuming you REMOVE the inner cardboard that comes with the game.

Updates

2019-04-14 - printed the survivor box - fits alright. I realized there's no real need to print the top box to hold the buildings, cars, and town limits since they are constrained inside the box.

2019-04-07 - crates, barrels, supports box fits well

2019-04-05 - zombie box, weapon box, card box, and token box, token holders are all printed and fit nicely together and hold the contents properly. v7 uploaded that has a 1.25mm added to the survivor box.

2019-04-03 - v6 uploaded. The zombie box was too short. Added 2.5mm

2019-04-02 - The gun and bullet box fit nicely on top of the token box and prevent the tokens from dislodging from the holders. Zombie box is up next.

2019-04-01 - The token holders are printed and look good. as far as height for the tokens are concerned. I'll be testing the token box next.

2019-03-19 - Will be printing over the week to test fit the stacking and box fitment. stay tuned!

Boxes

2 Stack column:

Bottom - Crates, barrels, support blocks

Top - survivor figures

3 stack column:

bottom - token container (use the token holders)

middle - guns, bullets, knife, bat, etc

top - zombies

Single tall box:

cards - both french and english decks and survivor cards. they'll all fit in this box, but it's a squeeze. I found it better to wrap the french deck up in plastic wrap and keep it tucked away below the zombie tower.

overall top box:

cars, buildings, rv

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK2S

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

5%

Filament: Amazon Basics PLA

Notes:

Nozzle Temp: 215C
Bed Temp: 60C

Skirt: 3 layers @ 10mm

Initial nozzle temp: 220C

initial bed temp: 70C

Category: Toy & Game Accessories

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License