Aluminum Slot mags for 1:10 crawler

Modeled literally off of a set of deep dish slots for MOPAR/Ford. Print these in the shiniest silver filament you can find. I use YOUSU off of Amazon (https://www.amazon.com/gp/product/B0854KYS6F)

It will only work with hubs that support the 12x6 bolt pattern, though it may be possible to design a retaining cap without destroying the look of the wheels. Use M2x12 or M2x14 for the lug bolts if you used my hub design (https://www.thingiverse.com/thing:4756096).

For best results, tap the holes for the m2 screws.

One-Piece Version

Files: aluminum_slots, retaining_ring_8_hole.stl

This is designed to print with minimal supports, so the wheel is one body, retaining ring another. You will need supports on the wheel part, but these should be easy to remove.

Mount the tires with the retaining ring using 8x M2x6 screws.

Mount with 6x M2x20 screws.

Two-Piece Version

Files: aluminum slots-inside, aluminum slots-outside.stl

Print with supports, mating side down.

Insert the two halves into your tire.

Align the hex hole for the axle. They only align properly one way.

Attach the 2 halves through the back using M2x6 screws.

Print Settings

Supports:

Yes

Filament:

pearlescent silver