MMU Reset Button

For other Prusa MMU stuff: https://www.thingiverse.com/AbeFM/collections/abes-mmu2-stuff

If you own a Prusa MMU2.0, then you know you press the reset button 15 times for every print that comes off the bed.

Which means finding a tool, trying not to shove it in the wrong place, etc.

I designed this little button to incorporate a little springiness to prevent accidental resets, and a little nub to hold it in.

Just not a lot to say about it - if you find it needs tweaking, let me know, it's a 10 minute design and there's room for improvement.

Print Settings

Rafts:

No

Supports:

No

Resolution:

200um

Infill:

minimal

Filament: meh TPU

Notes:

This pretty much needs to be done in a flexible material, print it upside down without support.
I use a stiffer TPU (~95A shore). Use plenty of fan, the part is small and can melt while printing.