Pwnagotchi Case

This is a remix of "Waveshare display (v1/v2) with a PiSugar 1200mAh battery and a carabiner loop" to support the PiSugar2 1200mAh (switched USB charging port/button, and added a slot for the power switch).

I made the case and lid a little "fatter" to better support the PiSugar2 (only 1mm, but it made a world of difference), and added heat dissipation slots in the lid, and I've also included a slightly larger button (the original "slipped" a little sideways when I tried using it).

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

0.15

Infill:

15%

Filament: Filamentive PETG Orange

Notes:

To get an interference fit on the lid, I needed to make it a little larger than "as supplied"; height was fine, but needed 0.5mm added to width and length). YMMV.