3D Models Household Other House Equipment

Simple & Strong Hook - V2

This is a dual version of my previous "Simple & Strong Hook - V1" design. The two hooks are placed at a 90 degree angle.

277

1110

3427

updated May 4, 2022

Makes

Comments

Makes only

Żona zadowolona!!!

This was perfect for holding my umbrellas near the door. I printed this "wall side down" on the print bed, which caused a little bit of drooping on the back side of the hook part, but overall printing without supports is probably fine. I used white PLA, 4 perimeters, and 40% infill for extra strength. Might be overkill, but whatever