Tower of Terror - Elevator Indicator

These models will allow you to create a replica of the Tower of Terror Elevator Indicator
17
73
1
672
updated May 5, 2022

Description

PDF

This are the models for the hand of the Tower of Terror Elevator Indicator. I did not make the original models, they were made by HRJunior on Thingiverse. I have made some changes, such as…

  • Reduced geometry complexity
  • Cut some sections to make them easier to print
  • Cut some sections to fit smaller beds

Printing this took roughly an entire spool.

You can adjust the infill on most parts to suite you and your print times. I wouldn't go lower than 10% on the back plates as you'll run the risk of holes if you do.

Tags



Model origin

The author remixed this model.

License