Spin to Win Motor Visualizer

I printed all the parts with the 0.1mm DETAIL preset in PrusaSlicer but the models are designed for 0.2mm if your printer is dialed in enough to manage the little details. 

The slices take like 3 min to print so you'll be doing a bunch of filament swaps to get this one done. I did a color change to white but you might be able to get away with a white marker if you aren't feeling like doubling your color swaps. The slices just snap into place on the spinner so don't need glue for holding them in.

I included a blank slice to allow for writing on or you could also leave out the slices and just cut our some colored paper and write your own messages on them. 

The spinner itself is separate from the magnet holder to allow mounting any kind of pin holder or the magnet directly to the back of the spinner. I didn't have the 8x3mm recommended magnets and so I improvised with a few 6x2mm and one of the magnets from the Prusa spare parts bag. If you do have the right magnets, I also included an STL of the ring for around the magnet

note: The summary says 9g of filament which may be accurate with the color change waste but the final model is around 5g without the magnet.