43mm Fork Seal Driver

This is a very easy print to create a fork seal driver to install new fork seals on my ZX-12R without damaging the seal. I'm planning on creating some for my other bikes as well, so keep an eye out :) If you want other sizes, just give me a comment.

Note: You will need to print two halves to fit around the fork tube.

Print Settings

Printer:

DaVinci 1.0a

Rafts:

Yes

Supports:

No

Resolution:

0.2

Infill:

40%

Notes:

I've upped the infill to 40% to make it a bit heavier, but you can go down to 20%.