Magnetic Case for Raspberry Pi B and 2.8 TFT

I've been searching for a clean raspberry pi case. Also, I wanted to avoid snap fits due to breakage, and screws seemed to be too slow when I wanted to get to the board quickly. I had used neodymium magnets (0.25") from Michael's craft store and tried it on the case. Wow.. the grip was excellent, but the magnets that close to the computer was a bit scary. However, I haven't seen any unusual behavior (yet).

The lid is a perfect fit for the Adafruit 2.8 TFT display.

The is plenty of room to get to the USB ports and the power and HDMI port. The sim card is also easy to remove.

Let me know what you think if you print it.

Print Settings

Printer Brand:

Ultimaker

Printer:

Ultimaker 3

Rafts:

No

Supports:

Yes

Resolution:

0.06

Infill:

20%

Filament: Inland PLA White