E3D V6 Mounting Plate for Anet A8 (fixed nut traps)

The mounting holes in the original were so large that the M3 nuts start spinning in them as soon as any appreciable torque is applied. In this remix, I have shrunk them to 6.4 mm (corner-to-corner), which in my experience produces a snug fit that keeps them from falling out or spinning in the trap.

I also shrunk the M4 holes a bit for the same snug fit, which should keep them from sliding around and will make bolting/unbolting the hotend a bit easier. (With the original, I jammed some Blu-Tack down the holes with the nuts to try to keep them in place.)

There was also a slight misalignment of the holes for the belt holder that has been fixed.

Print Settings

Printer Brand:

Anet

Printer:

A8

Rafts:

No

Supports:

No

Resolution:

0.2 mm

Infill:

40%