REMIX - Anycubic Vyper - Adapter for V6 E3D v.1.0 upgrade
Überarbeiteter Adapter for V6 E3D
61
1244
4
5724
updated May 1, 2022
Makes
Comments
Question. I'm looking at doing this upgrade for my Kobra Max. But I'm concerned about thermal tolerance of this adapter. Have you had any issues with this 3D printed adapter experiencing thermal exposure issues over time?
Thanks!
I was able to install this mod (using an E3D Volcano hotend) on my Kobra Plus as well but the auto leveling now fails. The assembly sits lower so it presses into the print bed. Is there a way to adjust this in the firmware? I'd rather not have to drill new holes and move the Z-limit switch upwards.
@X3D_239293 Hello! I'm planning to do this upgrade on my Kobra Max. Question. Have you had any auto-leveling issues. And do you have any concerns or issues with the adapter and thermal exposure? Thanks!
@Secrit_725612 @Secrit if you print it in petg or abs there is no issue with thermal tolerances, if you put the cable as it need to be at the back there is no issue with the auto-levelling ! the only thing I have issue with is if there is a clog its a little bit pain in a ass to have to unmount everything and redo the levelling because you'll never tight the screws the same way so you may have a little change of the first layer