Not a good model, sorry. It's too small, and the distance between the pegs and back is too small for it to actually fit a coin without toppling over.
Challenge Coin Stand
This is a basic stand that can hold challenge coins or another coin of about the same size.
11
145
2
593
updated May 1, 2022
Makes
Comments
@CmdrKeen_25079 See if you can scale it up in your slicing software so it fits the size of your coin better. The model itself is the size for the coin I was using so you may have to change it to fit your needs. (edited)
Not very stable. Would benefit from more distance between front and back supports.
I had trouble getting the stand to support the coin without toppling.
@KarlPalutke_1061582 Sorry, the coin I modeled this for seems to be a good bit smaller than yours. Maybe try to scale it up to see if it fits better?
