This little experiment was because I needed a 1164mm timing belt for a camera slider project. The belt is on order but is going to take about a week to get here so I designed a quick one to print so I can get this project going ASAP.
I printed it off in Ninjaflex it took about 3 hours on the Taz6, and so far it works pretty good.
Printer Brand:
LulzBot
Printer:
TAZ 6
Rafts:
No
Supports:
No
Notes:
Print this in Ninjaflex or Semiflex
OnShape link:
https://cad.onshape.com/documents/7089870465b1c9d0a99abbda/w/662b4546814116a86515d4a8/e/4b813f4befde231507dcb67brnrnI made a 1164mm contour that would fit my bed and then repeated the GT2 belt pattern.
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.