After designing and using my original vape stand for a while (https://www.thingiverse.com/thing:2450149) we started to accumulate a number of 60mL and 100mL juice bottles, and a bunch of additional tips and such that my original design didn't accommodate. So, I dove back in and designed a bigger version to hold more/bigger bottles. The bottle slots are all sized for 100mL, but can hold 60mL or 30mL without too much jiggling around.
Additionally, I added a drawer at the base of the stand that is deep enough to hold an additional iStick pico, plus some spare batteries, coils, tanks, and tips.
The drawer's sides and bottom are all designed at 3mm thickness, which I know is probably way overkill. After using for a while, I may cut those down to provide a little more room in the drawer, and to save on filament.
I printed both of these at 100% and the tolerance for the drawer was about perfect. It slides easily without any noticeable left/right wobble, and the front sits flush with the rest of the stand when closed.
Need a place to put your picos when driving? Does your car have a cassette deck? https://www.thingiverse.com/thing:2768508
Printer:
Monoprice Maker Select V2
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
15%
Notes:
Could probably look really nice at a higher resolution, but I printed at 0.3mm to save time and it still looks pretty good.
Category: OrganizationThe author marked this model as their own original creation. Imported from Thingiverse.