Filament Guide Dual Ball Bearing with Ball and Socket

This is another filament guide. It has dual ball bearings and uses a ball and socket so it can be rotated to any…
0m
1× print file
0.00 g
undefined
10
72
0
369
updated April 30, 2022

Description

PDF

This is another filament guide. It has dual ball bearings and uses a ball and socket so it can be rotated to any position. It is designed to be mounted on 2020 extrusion with 2 screws and extrusion nuts sized either 3mm or 4mm. There are two mounts that should fit the needs of many printers.

You will need two 608 bearings, 2 screws and 2 washers to put it together. I think the screws I used were 3mm x 8.

Print Settings

Supports:

Yes

Resolution:

0.2

Infill:

30%-60%


Notes:

Print with a Brim

I printed this several times and I found the best orientation for the top mount was as in picture 3. Use support with an angle of 65 degrees and it will only put a little support on the front of the threaded area.

I used Cura 4.0 with adaptive layering on. I've included the gcode file I used.

Category: 3D Printer Accessories

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License