Dumpling Maker / Press (w/ Fusion360 link)

This is a simple but rigid dumpling maker (or press) that I did for the dumpling wrappers that we are using at home (~12cm diameter). I tried a lot of versions in thingiverse but they were difficult to be printed or too weak and break easily.

It's quite challenging to design it, it took some hours to do it the correct way. I think that for the average user is too difficult, so I have included below the link to the Fusion360 file so that you can download and edit it as you wish. Fusion360 link

NOTE: Two M5 bolts are needed, with a thread length of about 12mm, and you can add some superglue to hold it to the holes of the outer part.

There are 2 STL versions, the only difference is the outer diameter

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

No

Supports:

No

Resolution:

0.24mm

Infill:

25%

Filament: HatchBox PLA Grey

Notes:

It's a simple print. Takes a while.