Ruler Holder

This holder for the TronXY X5S allows for mounting a thin steel ruler that runs along the Z-axis plates. Makes it easier to check if the two Z-drives are at the same height. Print twice and buy two cheap 500 mm steel rulers with a hole at one end.

Extra material for mounting:

4x M4 10mm screws (I prefer the ones with cylindrical head and hex key),

2x T-nuts,

2x self-locking nuts M4 (insert into hexagonal hole)

Print Settings

Printer:

TronXY X5S

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

0.2mm

Infill:

15%

Notes:

Don't print at too low Z-resolution. I've had severe bridging issues with the upper of the triangular reinforcements.