This is a replica of an Euro 10 cent coin for use as a coaster. The diameter is 10.1 cm (3.9 inches).
You can use any filament color which you like for the Euro 10 cent coaster. The original color of the 10 cent coin is a gold color called "Nordic Gold".
Let the design to be the upper side on your printer's build plate. The flat side is at the bottom.
The Euro 10 cent coin now comes in 3 flavours.
Coin coaster with top design and flat bottom side with 3 holes for the rubber stoppers on the bottom side. This design is printed in one go. Of course you can use the coin as a coaster also without the rubber stoppers.
Coin coaster with top and bottom design. There are 3 holes for the rubber stoppers on the bottom side. The print consists of the top and bottom part separate. The parts must be glued together after the print with the flat sides facing each other. Of course you can use the coin as a coaster also without the rubber stoppers.
Pure coin with top and bottom design without any holes on the bottom part. The print consists of the top and bottom part separate. The parts must be glued together after the print with the flat sides facing each other.
Enjoy printing these items.
Printer:
FLSUN Super Racer
Rafts:
No
Supports:
No
Resolution:
0.2 mm initial layer, 0.2 mm layer height
Infill:
20 %
Filament:
MKOEM PLASilk Light Gold
Notes:
Nozzle not larger than 0.4 mm to print the fine details.
Post-Printing =============Glue round rubber or foam sheets (optional)
You may want to glue 3 round 10 mm (0.4 inches) rubber or foam sheets with 2.5 mm thickness to the bottom holes of coin A and B. This will make the coaster sit on the table in a stable way.
Coin design
The coin was designed with Blender. I have designed the flat base coin first. Using a reference photo I have extruded points to match the text and ornaments on the top surface.
When the print is finished let the build plate cool down. Do not force the two coins of type B and C to come off, as they are not very thick. You may want to use isopropyl around the corners, if the coins stick too much. Glue the two parts together with a glue appropriate for the material you are using.
Category: Coins & BadgesThe author marked this model as their own original creation. Imported from Thingiverse.