Emerson Trimble

@EmersonT445_1467259

works great.. just confused about where the gnd wire for the hotend goes for the Ender 3V2

16

Tyler

@Tyler_280669

Amazing work. Thank You! Added some support brackets to securly lock in Place. Printed in ASA and Welded together using Acetone (edited)

16

luigi20000

@luigi20000

Great part looks great Fits great

7

Scottieeee

@Scottieeee_524195

Can u print just the left side I wanted to keep the draws

9

trichofan

@trichofan_383172

This worked great for my IDEX project. I added a second skr mini control board and there is still enough room inside for a raspberry pi. The only other change that I made was adding heat set inserts for the lid screws.

10

belak

@belak_389524

@trichofan_383172 Do you still have that file handy by any chance? I'm trying my hand at adding heat-set inserts, but if you've already got something I'd rather use that.

15

N_F_B

@N_F_B

Great design! However, I found a few improvements, to be seen in my remix.

11

Fstoka

@Fstoka

@N_F_B could you please share the stl for level wheels holder? how good are they?

15

N_F_B

@N_F_B

@Fstoka Printed those a long time ago, unfortunately I don't have it anymore

12

krufdor

@krufdor

Great design. Had some trouble fitting USB cables to the raspberry pi. But otherwise everything was smooth installing it.

18

pedrolamas

@pedrolamas

@krufdor Thank you for your comments! Indeed, it can be very tricky to use a USB cable, part of the reason why I personally prefer using a serial connection direct to the Raspberry Pi header pins.