Most cell phone camera tripod mounts are WAY too complicated. Like trying to kill a gnat with a sledgehammer. And most limit you you to one cell phone type or manufacturer.
This is a very simple universal mount. It requires no extra hardware and only a rubber band to "adjust" to any phone. It is pre-threaded for 1/4" - 20 for a tripod screw.
It also acts as a temporary stand on a flat surface with limited forward and back tilt. But it is not intended as a stand, just a tripod adapter.
I have not run across any phone this would not work with, so I put "universal" in the name.
It prints easily with 8% infill and no supports.
Printer:
ANET A-8
Resolution:
.2mm
Infill:
8%
Category: CameraThe author marked this model as their own original creation. Imported from Thingiverse.