P365 15rd Magazine Grip

Sig Sauer's 15rd magazine for the P365 does not come with a palm rest like the 12rd magazine does. This makes shooting it awkward and uncomfortable. I decided to design and print my solution to this problem and share that solution with the community. To attach the print to the magazine: Clean the surfaces with isopropyl alcohol or any similar cleaning solution. Rough up the surfaces of the magazine and the bottom of the print with sandpaper. I then used JB weld (any good epoxy will do) and a clamp to attach the two surfaces. Leave for a couple hours to allow for the epoxy to cure. When clamping, make sure the bottom (in relation to the firearm) of the print is flush with the bottom of the metal part of the magazine. If not, you will have to sand/melt the top part of the print in order for the magazine to seat reliably in the firearm.

Designed in Solidworks

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Infill:

100

Filament:

Doesn't matter but black looks best