This is the next design I reworked for printing. Look at the astro model page to understand where I started with this series.
Print settings for photographed model using PrusaSlicer-2.3.1 based on Slic3r:
0.30mm DRAFT Infill: 20% Generic PETG
(3) - bot_leg_section_1
(3) - bot_leg_section_2
(3) - bot_leg_section_3
0.30mm DRAFT(modified) Infill: 100% Generic PETG
(3) - bot_threaded_rod_to_table_top_connector
(3) - bot_dished_washer
(3) - bot_glide
Hardware list:
(3) 1/4-20×21.5” threaded rod
(6) 1/4-20 hex nuts
(3) 1/4” washers
(9) 1-1/4” pocket hole screws
Tabletop router templates and connector layout jig are included.
Assembly video on YouTube. Search “bot table assembly video”
The author marked this model as their own original creation.