Small tray with embedded magnets

My mother in law wanted a magnetic pincushion, so I whipped up a quick tray iFusion 360. It uses 5 embedded 8x3 disc mag
4
10
0
196
updated August 28, 2022

Description

PDF

My mother in law wanted a magnetic pincushion, so I whipped up a quick tray to use as one in Fusion 360.

It uses 5 embedded 8x3 disc magnets.

To embed the magnets set your slicer to pause at the layer where it closes over the void for the magnets.

Based on the calibration of your printer you might want to scale it up a bit if you find it wont fit, but on mine they dropped in but stayed snug.

Check out my other models here

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License