4 inch flexible hose magnet coupler. The magnets are overprinted so that they are completely embedded into the coupler. There is a 2 degree taper on the hose insert to allow it to slip on easier.
The STEP file is included.
Overall Height: 1.75 inches
Overall Width: 5.25 inches
Material: Hatchbox ABS
Vertical Perimeters: 4
Horizontal Perimeters: 5
Infill: 42%
Infill Type: Rectilinear
Printer Utilized: Voron 2.4
No supports or post processing is required
The top of the magnet cavity is 4.2mm above the build plate, a print pause needs to be inserted at this point in the slicer to place the magnets.
More detailed information about printer pauses from Prusa
In order for two couplings to properly mate the magnet poles should alternate.
Print paused at 4.2mm
Alternate the magnet poles
Category: Tools
The author marked this model as their own original creation. Imported from Thingiverse.