Great design. Thank you! Scaled by 103%. I wish I hadn't scaled the Z-axis, too, just the XY.
BCG & CMMG BCG Carry Case
I leave my BCG out of my gun for storage as well as swap between it and CMMG bolt. I needed a place to put it to keep…
46
468
4
1810
updated December 3, 2023
Makes
Comments
@AndyF_594171 stuff a piece of desiccant or print a small cylinder shim for the bottom. Could use foam but I would add some oil to keep moisture out of it
This is awesome! Make sure to flip the lid to avoid a huge overhang. I went %104, but should have done %103.
This was awesome. Every other model has a bad fit, loose lids or something. This just works. And it looks awesome.
Scaled up to 103%.
I guess only the large lid is needed, since it fits both the 22 kit and the carrier.
Thanks for this!
Could you also make for the AR-10?
@PeterSkinnes_945568
I never thought of a BCG for the -10. I suppose you only need the short lid for that right?
@Norkkon_252760 gave this to a friend, but yes, that is how I interpreted him
My Aero BCG got stuck in the case, it's not large enough. I recommend adding some clearance on the inside.
@raleigh_littl_205316 thanks for the print and comment. The model was sized for the exact bolt dimension. Printer typically erase clearance and I don’t think I made much for clearance. The suggestion in the details was to scale the entire model to 104% to create the clearance needed. Yes I could have added clearance but the scale was even easier approach, albeit lazy.
can this be printed on its side? Im showing 11+hours and 65M of material (the CMMG BCG case)
@Tdavis501_1673884
Potentially, but vertical is the best orientation
Super Transport und Aufbewahrungsbox empfehle aber 104% zu nehmen sonst deutlich zu eng. Habe es mit PETG gedruckt und 6mm Nozzel
