This is a simple Waterpik tip holder that holds 2 tips - leaving enough room below to allow for air circulation to aid in drying.
The legs are 37mm tall (not including the top and bottom surfaces).
The holes are 8mm in diameter.
I designed this to prove to my wife that my 3d printer purchase was a good idea after all. So far mission accomplished.
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Infill:
20%
Notes:
Flip it on it's back and it should print fine without supports.
Category: Bathroom
The author marked this model as their own original creation. Imported from Thingiverse.