Easy Assembly Ultra Ball

Based on my Pokeball design: https://www.thingiverse.com/thing:3147999

Easy to print and assemble Ultra Ball

All parts are printed separately and placed together. The ring in the middle can be any colour and is just there to position the other parts. Everything just slots together.

Glued to stay together permanently, the yellow H marking should be glued in as it does not stay in on it's own. You can scale up the internal ring in the z direction to decrease the tolerance and make a tighter fit.

100% size is 40mm

Top and bottom should be printed at low layer height, I used 0.12. other parts can be any layer height. I used supports on the underside of the domes and yellow H Marking. Also sanded the underside of the yellow part a bit to get it to fit nicely.

Custom Section