Small roof with posts - for well, etc.

I made this for the GF's fairy garden. Originally to cover a well she made from clay, but it's handy for all sorts of things. It can be stretched along the long axis, scaled, etc.for a variety of uses. The top edges are chamfered at 45 degrees for a clean edge.

There's two styles of roofs and supports, and two lengths of supports.

Roofs: Scalloped and not scalloped. Each with and without grooves on the bottom. The grooves are for placement of the supports - it makes assembly easier. These need supports, but I only use 10%. The grooves are only .7mm deep and fir the supports snugly.

Supports: Plain and fancy. Fancy has curved accents. Woo-hoo. Short and long. Identical, just with an extra inch on the bottom.

Print two of each and you're set. Print at .2 or finer. I used wood colored PLA and dry brushed. Assembled with CA glue.

Post-Printing

Attach supports first.

Top should match cleanly.