theCUBE - Display Box

Other required material:

• 6 pcs PMMA plates 200x200x4 mm
• superglue (optional, depending on precision of printed parts)

1. Lid

	Join 4x top_bar (green) with 4x top_corner around 1x PMMA plate (blue)
	Add 4xtop_corner_joint (orange). Use glue if does not hold well.
	Finished top lid.

2. Vertical Bars Preparation

	Place a foot (black) on the vertical_bar (green). Use 2x pin (blue) to secure the foot on place.
	Insert 2x pin (blue) into empty holes

3. Base

	Use vertical bars from prevoius step, 1x PMMA plate and 4x bottom_bars (purple) and connect the together as pictured on the left.
	Insert bottom_corner_joint (orange) into all 4 corners. Use glue if necessary.

3. Side Walls

	Insert PMMA plate () between vertical_bars
	Add bridge (orange). Use glue if needed but let it dry well because you might not be able to remove top lid then :)
	Repeat previous steps for other sides.

4. Final

Put your items inside and place the lid on to the top