Printed this with 4 shells and 20% infill. I did have to add a custom block modifier to help support the bottom edge of the wire trough as you see in the photos. Enjoy
File and Prints of models not to sell or resale
Printer:
gMax XT+
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament:
Hobby King PLAMatte Blue
Notes:
Needs a custom support or modifier to help support the horizontal printing when it starts the top edge of the wire trough. Keep it 0.2 below the first long pull of filament. You will see this in the slicing. Please check photos.
Category: GadgetsThe author marked this model as their own original creation. Imported from Thingiverse.