Anet A2 bottom Z-mount

These are Anet A2 Z-Stepper mounts for both sides of the printer. I made this for a friend since the existing options were a bit bendy. This will not bend or only minimal once the stepper is installed in it tightly. Its tested and will fit & work.

Again its stability comes from the tension between the stepper motor and the support resting on the aluminum profile. You can add supports here but they will be of marginal utility at best or waste plastic.

Print Settings

Resolution:

.24-,26

Infill:

40%-60%

Notes:

Honecomb infill pattern or similar recommended