Sennheiser G2/G3/G4 Lavalier Hardmount

Model

This allows you to hard mount a Sennheiser G2/G3/G4 RX or TX Lavalier pack on your camera rig / audio recorder. You can either use the stainless steel belt buckle to attach the 3D printed plate or double sided tape (Recommended - That's what I'm using).

The (wedgie style) quick release adapter is designed to fit the common quick releases that you will find from Kondor Blue, Lenz Camera Tools, AbelCine 16X9 and other generic camera brands. Some of these are very slightly incompatible with each other so you may need to modify the adapter or make your own.

Print Settings

I would highly recommend printing these with at least 4+ perimeters and at least 3 bottom / top layers. The thread walls for the screw thread adapters need to be strong enough not to crack and if using the (wedgie style) quick release adapter these tend to crack when screws are overtightened.

Parts needed

(2x - 5x) ¼" UNC to 3/8" UNC Screw Thread adapters

Optional: (2x) ¼" UNC 1 / 2 " Long Countersunk Screws

Installation - (Please see photos for guidance)

(1) Screw in the ¼ to 3/8 screw thread adapters to the 3/8" UNC holes on the main plate. If using a (Wedgie style) quick release foot, screw it in using 2x ¼" UNC 1 / 2 " long countersunk screws.

(2) Remove the stainless steel belt buckle from the lav pack, place it over the 3d print and place both the 3d print and belt buckle back onto the lav pack. (If you are using double sided tape place it on the back of the 3d print to stick it onto the lav pack.

(3) Now clip in the belt buckle, the 3d print should not interfere with this. (Please also note that it is possible to mount the belt buckle and 3d print upside down, this is fine, it is user preference which way the adapter goes).

Print Settings

Rafts:

Doesn't Matter

Supports:

Not needed

Resolution:

0.12mm

Infill:

30%+

Perimeters:

At least 4x

Filament: Any PLA, PETG, ABS, Nylon or any other sturdy filament.

PLEASE NOTE
Please contact me first if you are thinking of printing these and selling them. You MUST provide a link to the original Printables page!